Paddleboard Set-Up Guide

1. Make sure the board’s valve is UP before inflating (push down & turn 1/4, to alternate between UP & DOWN position)
2. Make sure hose is connected to “INF” or “OUT” side of Pump
3. Make sure to start on “DOUBLE ACTION” setting on Pump, when reaching 8+ psi switch to “SINGLE ACTION“
4. Fill SUP up to minimum of 10 psi & up to maximum of 15 psi (If you are renting the X10, fill the side chambers to 3-4 psi)
5. Detach hose and screw on valve cover cap (IF AIR BLOWS BACK OUT: Make sure the valve is UP, see step 1.)
6. Attach FIN to bottom of board